Interested to Buy Any Domain ? << Click Here >> for more details...
why transformer ratings in kva?
- 99 Answers
- 231981 Views
- Bhel, College School Exams Tests, DOW, Emco, Esab, GE, KCP, PGCVL, Sodexo, TCS, vtps, Wipro, I also Faced
- E-Mail Answers
Answer Posted / karan lal
ironloss is depends in voltage and copper loss is
depends in current.so the transformer ratings in kva
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Discuss about gear cutting machines.
how did the testing of protection relays done through current injection
What is the difference between Encoder and Resolver?
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
How many double suspension hardware fittings are required on a double circuit transmission tower?
diff b/w elcb and rccb
How cmd is calculated in case of energy neters
The height to which the liquid in a tank to be maintained for a certain constant velocity?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Iin ESP why positive is grounded ? why not negative ?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
What is mason's gain formula?
explain why core loss of a transformer is almost constant under different load conditions when connected across a constant voltage and constant frequency.
How we calculate the current carrying capacity of H.T. cabel?
