Interested to Buy Any Domain ? << Click Here >> for more details...
what is cogging and crawling
- 20 Answers
- 85953 Views
- ABB, Ashok Leyland, Bharat Bijlee, BMRCL, MN Dastur, Siemens, I also Faced
- E-Mail Answers
Answer Posted / dharm veer verma
Induction motors have a series of slots in the stator and in the rotor. These slots should not be equal in number because if they are, there is a good chance that the motor will not start at all due to a characteristic known as cogging. The slots will align like a stepper motor.
For this reason, there are an unequal number of slots in the rotor and in the stator, but there can still be situations where the slot frequencies coincide with harmonic frequencies and this can cause torque modulations. The slots are skewed to keep an overlap on all slots to reduce this problem.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
kVA rating of ordinary transformer is increased when connected as an auto transformer because A transformation ratio increased B secondary voltage increased C energy is transferred both inductively and conductively D secondary current increased
can i use 2000/5A Clamp meter to measure HT cable
What happens if the Capacitive Voltage Transformer Primary neutral is not earthed. There is a CVT between Transformer and source, and the CVT neutral of the transformer is not earthed, does it effect the transformer while charging or does it effect the transformer charging process.
66kv under ground cable how to layaing in ground any special case two ckt r runing
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
power transmission pole used one support , that only for support or earthing
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
Why squirrel cage motor can only use with low starting loads ?
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
what are the usual topology of transformers at different substations in the power system and why that particular topology is choosen. what are the limitaions of that topology?
How cmd is calculated in case of energy neters
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
What are the main faults of DC generators?
