Interested to Buy Any Domain ? << Click Here >> for more details...
why do we use bundle conductors instead of using single
conductor of larger size for high voltage transmission?
- 7 Answers
- 21696 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikalp dhiman
Extreme High Voltage carrying lines causes corona loss.to reduce this loss we use bundled conductors.These consists of 2,3,or many more conductors in bundle.Each conductor carries equally distributed among these conductors(in bundle).Due to this corona loss reduces
CORONA LOSS--High voltages ionises nearby air which causes power loss and affects communication wires.
| Is This Answer Correct ? | 13 Yes | 3 No |
Post New Answer View All Answers
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
Brief working principle of stabilizer,application & safety precautions
What is the slip speed?
How wire size can define in electrical wiring? What is the ratio?
What are the types of control system?
What are the factor to be consider for CT selection in 132kV substation?
What is the difference between a fuse and a breaker?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?
how to check ac servo motor
What is the formula to calculate the size of Aluminium and copper cable?
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
what is the solution for meger test failed the MV cable?
