Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rathod
Dear Freinds,
Shocks is generated by VOLTAGE(Potential Difference).
If you touch Current injection trolly output, which have to
much higher current,nothing will happend. But if you touch
high voltage line.....think......clean bold..
but keep in mind that whatever the enjuries in body,it is
beacuse of current flow....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how many load we can take for lighting
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
What are books to be referred for KPTCL exam?
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
Formulae for calculating the transmission line losses for different voltage levels
What is the basic of DTH.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
How you will determine the volume of oil in a particular Distribution transformer.
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
what is load vs Torque curve & why it is used?
