Interested to Buy Any Domain ? << Click Here >> for more details...
if we supply DC power to AC transformer then what its result?
- 15 Answers
- 17201 Views
- I also Faced
- E-Mail Answers
Answer Posted / alok ranjan
when dc supply is given to the transformer momentary emf will be generated at the secondary side and will collapse suddenly.
because flux does not change periodically due to dc supply.it changes only when it is switched from off to on or on to off.
primary coil may burn but Burning or not burning of primary depends on design consideration whether it can carry current according to applied voltage or not.because for dc,inductance will be zero so resistance of primary will be less than ac impedance, so current and I^2R loss will increase.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is size of 3phase 4wire cable to be used for 11 ton ductable A.C and how to calculate cable size for different load
Why PS class CT is always preferred for Differential protection?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
how tto ingress mw in turbine explain.procedure ?
what is residuel magnetism. and how order lead acid batteries for 24 volt. emergency lighting system.
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
what is the principle of operation of CFL ??
The simple way of finding the leakage quantity and % in compressed air distribution system
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
