if we supply DC power to AC transformer then what its result?
- 15 Answers
- 14495 Views
- I also Faced
- E-Mail Answers
Answer Posted / alok ranjan
when dc supply will be given to the transformer momentary emf will be generated at the secondary side and will collapse suddenly.
because flux does not change periodically due to dc supply.it changes only when it is switched from off to on or on to off.
primary coil may burn but Burning or not burning of primary depends on design consideration whether it can carry current according to applied voltage or not.because for dc,inductance will be zero so resistance of primary will be less than ac impedance, so current and I^2R loss will increase.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define step response?
what is the difference between general inverter and solor inverter clerly explain plz
at work i have a genertor/alternater what is the easyest way to work out if it is dc or ac?
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
What is the formula to calculate the rating of a three phase miniature circuit breaker
why we can use 1 to 5V dc
What is the difference between PLC and Embeded system
How to calculate Ith (I thermal) for curent transformer
Can anybody tell abt concrete encased earthing or grounding?
In cable sizing calculation (determining the max route length of cable) why we choose the shortest length between cable length of full load current Iflc & starting current Istart?
I have 4 DG set with 1500KVA rating. system breakers are 11KV & alternator are 415 Volts. Between alternator & breaker one stepup transformer used. i want to Know what is max. resistance for body earthing & 415 & 11KV V Neuteal earthing. my fault current is 14 times for 2 sec.
How many turns are there in primary winding? (In Transformer)
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
