what is the difference between earthing and grounding?
- 6 Answers
- 8447 Views
- Bhel, Wipro, I also Faced
- E-Mail Answers
Answer Posted / kuldeep
grounding is use to protect the instruments from flow of
large current while earthing is the old name of grounding
done by the peoples for both purposes 1_to save the
instruments from the large current 2_to increase the level
of voltage in case of low voltage by giving water to that
place where earthing is carried out
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Why GRR starts from 60% of motor speed why not less than 60%?
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
how to test YNyn0 vector group in transformer?
WE know that for Inductor X=2pifL,In DC f=0,then X=0 so,V=IX=0;But In the DC excitation of rotor of AC generator,DC motor field coil which coils are inductor so why does not applying DC voltage short the rotor coil of AC generator and field coil of motor?If it would then DC source might be damaged but it is not happened. Why does the strand conductor of Electrical power transmission line make twist?
which protection used in power plant?
explain all the classes with example
What is nichols chart?
How 48-relay (incomplete sequence) functions?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
Why do we use copper cable for HT Supply and why not Aluminium?
How to calculate the sag of OPGW during stringing???
how choose conductor&depending upon load
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
