Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Polarisation index value ? (pi value)and
simple definition of polarisation index ?
- 15 Answers
- 79511 Views
- Essar, I also Faced
- E-Mail Answers
Answer Posted / s.ali
Polarisation or PI is the ratio of 10 minutes meggar value
to that of 1 minute.This value must not be less than 1, if
it is so then equipment like motor or transformer shuld not
be put into service for operation.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
i have 500 amp inductive load of motors ,,,pleas tell me how can i calculate for capacitor bank for improving my power factor to 99 .....calcullations for capacitor bank,,,,
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
WHAT IS VCB SAFETY
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What are the transformer losses?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
Batteries. What is the difference between Lead and Nickel batteries ?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
Under wat condition statcom operates as an inductor for the transmission line?
what reason of line current and phase current in star connection and line current and phase current not equal in delta connection?
What is shutdown of electrical sub station?
plz send me the procedure and syllabus for mseb exam
