Interested to Buy Any Domain ? << Click Here >> for more details...
We all have seen transmission and Distribution lines In
transmission lines the voltage is high and current is low(to
reduce I^2r loss) and in distribution lines voltage is low
but current is high however the size of transmission wires
is bigger than that of distribution wires even though the
amount of current carried by the distribution lines is more
than that of transmission lines why?
- 4 Answers
- 6772 Views
- I also Faced
- E-Mail Answers
Answer Posted / pawan
Murali ans right nd also transmission line wire mechnical strength should be high compare 2 distribution line so transmisson line conductor thik compare 2 distribution line.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
why cable i burning without tripping. how can protect led street lights
Formulae for calculating the transmission line losses for different voltage levels
what is the significance of tan&delta and how it performed in power transformer
what is the electrical?
What is the unit of magnetic flux density?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what & how to check the lightning arrester
hr round
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
How to calculate or formula to calculate rhe power in 2 phase system ??
Why GRR starts from 60% of motor speed why not less than 60%?
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
Explain and give me an example of a time when you had to explain some new procedures to your co-workers for quality service delivery, how did you go about it?
