Suppose we are having two router i.e. Router1 and Router 2
connected with each other on Serial Link,Router Network
having ip 192.168.1.0/24.
1> which ip is used at router1 and router2 interface?
2>Which Command is used to assign ip to router1 and router2
interface?
- 1 Answers
- 2937 Views
- I also Faced
- E-Mail Answers
Answer Posted / unknown
CONF T
INTERFACE FA0/0
IP ADDRESS <ADDRESS> <MASK>
A worst question i have ever seen... Please maintain the
Standred
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is ping utility?
What is the difference between cross cable and straight cable?
What is the meaning of synchronization?
What are some standards supported by the Presentation layer?
Mention what does data packets consist of?
When ospf protocol advertise its routing table?
What is loop back ip in ipv6?
Explain the types of ospf configuration?
Can you explain voluntary and compulsory tunnels?
Can you explain VPN tunneled packet in detail?
In port based access-list which command u give instead of ip?
What is ospf? Describe it.
What is fcs?
Explain what are the ranges of private ips?
Mention what BOOTP is?
