Interested to Buy Any Domain ? << Click Here >> for more details...
In separator VFD frequently trip with OVER VOLTAGE Fault
What is the reason?
- 4 Answers
- 8306 Views
- I also Faced
- E-Mail Answers
Answer Posted / jayamohanan
YOU HAVE TO CHECK THE OVER VOLTAGE SETTING OF THE VFD,THAT SHOULD BE ABOUT 420 TO 430 FOR THREE PHASE MOTORS AND 240-250 FOR SINGLE PHASE.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
where proximity sensor installed on tank in loading arm application
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
dear sir we have insatlled positioner model no.sipart PS2 make Siemens at our control valves . now problem is if we want to increase the response of valve opening speedy /fast. what parameters do we change for positioner ? any idea. please guide us.
how is work pressure switch& level switch?what is the principle of this?
what are the diff. in servo and regulatory control?
give me the formula for analog to digital converter and also d to a converter
What is the Working principle of Dozing valve?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
how to calibrate steam control valve in steam turbine
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
, Instrument Index, P&ID review, I/O schedule, datasheet, DCS / Analyzers specifications, loop diagrams, hook-up drawings.
