Interested to Buy Any Domain ? << Click Here >> for more details...
what is the cutting length for circular ring???please
clarify.
- 12 Answers
- 59011 Views
- ACC, ATS, KCC, I also Faced
- E-Mail Answers
Answer Posted / partha mitra
Thanks for your reply.But Is there any deduction?for
exemple a rectangular ring there is a deduction (2d) for
each bend.please clarify.
| Is This Answer Correct ? | 16 Yes | 5 No |
Post New Answer View All Answers
in design case of structural member best suitrable percentage of steel limit is what
what is mean by c32/40s concrete class
what do you understand by M25 concrete
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
What is the development length given in pile?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
Suggest how many column, beem, etc required for 30 mtrs x 21 mtrs width x 8mtrs height for industrial shed of ground floor. I want to know the quantity of tmt steel consumption and Concrete consumption for budgeting
how to compute slab reinforcements on step by step procedures??
How and where are aqueducts built?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
i have four storeyed rcc building.basement of the building is around 34 years old.it does not have pillar support.it is having lintel steel support at every 7 feet of construction. how long this building will lost long . can any body help me in this regard
Explain what are the skills required to become an architect?
How reactor of SBR installed , is it be over ground, fully under ground or semi sunk ?
For the calculation of bearing pressure below the footing, to know whether it is below the safe bearing pressure of the soil, the unit of RCC below ground level to be taken is 25 KN/m3 or (25-15)KN/m3, where 25 is the unit weight of RCC and 15 is the unit weight of soil and whether the weight of backfilling to be taken?
rcc floor to floor 4m. in column reinforcement where we provide lap in exact location.
