Answer Posted / nithindas1947
electronic control unit
| Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
What is the three method of heat transfer?
In a vehicle, which is going straight ahead at N rpm, if the left wheel rotates forward at n rpm, then the resultant speed of the right wheel will be a) N+n b) N-n c) N/n d) Nn
Do the design & fittings depend on the type of the vehicle engine? Why is petrol used for engines only & vice versa.
What do you understand by ductile-brittle transition temperature?
What is the difference between bs2 & bs3 engine?
Stiff spring is used in the selector mechanism a) To prevent engagement of two gears simultaneously b) To prevent engagement of reverse gear c) To facilitate the gear selection d) To avoid the necessity of having neutral gear
What size of a compressor (cfm) is recommended for the purpose of inflating car tyres, spray painting, etc.?
The function of the final drive is to a) Provide a permanent speed reduction b) To turn the drive round through 90o c) To provide drive to the rear wheels d) all of the above
i have chines vehicle Grand Tiger now its AC compressor become jam what should i do i have not found new in market
Single reduction is used in final drive when it is about a) 6:1 b) 8:1 c) 10:1 d) 12:1
How are calculate the Speedometer ratio in the vehicle?
How bhp can be calculated in si units?
Is boiler a closed system?
what is a stage time
face to face first interview for the post of service engineer to question
