Interested to Buy Any Domain ? << Click Here >> for more details...
What is expansion of SMART Instruments? And What is it?
- 35 Answers
- 57457 Views
- Atesco, I also Faced
- E-Mail Answers
Answer Posted / sajesh
single modules addressable rangeble transducers
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Draw symbols of the following :
why we are using drum level control valve air to close?
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
What is the use of GMV in turbine?
How r the calculation of process line mpm.
how can leve transmetter calibate in feild .and also put cv and flow plz .....
State some of balance principle’ advantages?
How an rtd work, and what volts/current goes to a rtd to measure the resistance?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
What is the difference bitween control net scaner and device net scaner
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is stripper & spilitter ? Diffrence in this.?
how to relay switch sense the fault?
