Answer Posted / wareagle

Has nothing to do with load. Depends on system voltage.

if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?

1984

---

if a.c supply is given to the motor,, what happen?

2224

---

sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.

2018

---

What is cut-off rate?

1274

---

in shunt clippers why a resistor is used in sereis with the input

2168

---

What id difference between power and energy?

1462

---

what is doubling factor in making current of a breaker?

2117

---

Please explain me about Relay curves and their sources to read ?

1860

---

what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW

8688

---

What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.

2741

---

salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers

2143

---

How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com

2169

---

what is meant by motor startup supervision & motor load jam protection ?

6083

---

dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish

2416

---

Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??

2462

---