Interested to Buy Any Domain ? << Click Here >> for more details...
We all have seen transmission and Distribution lines In
transmission lines the voltage is high and current is low(to
reduce I^2r loss) and in distribution lines voltage is low
but current is high however the size of transmission wires
is bigger than that of distribution wires even though the
amount of current carried by the distribution lines is more
than that of transmission lines why?
- 4 Answers
- 6771 Views
- I also Faced
- E-Mail Answers
Answer Posted / murali290
In transmission the power carried is very high compared to
distribution.even low currents in transmission means it is
of range Kilo Amps ,inorder to carrying that much high
power(VI).
where as in distribution low power is carrying .even though
high currents means not that much as in transmission.hence
small conductors are present in distribution compared to
transmission
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
What are the different circuits in thermal power plant?
WTA used cb?
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
What mean by MLTP
explain Density
why to use freewheeling diode ( diode in revers bias mode) across dc coil
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
explain me the relation between torque, frequency,speed,voltage and current in the 3 phase induction motor?
What is the meaning of C1, C61, C91 cable
How to calculate the sag of OPGW during stringing???
why chock were used in old tubelights but are not newest tubelights?
