Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / deepak nayak
A thermocouple consists of two conductors of different
materials (usually metal alloys) that produce a voltage in
the vicinity of the point where the two conductors are in
contact. The voltage produced is dependent on, but not
necessarily proportional to, the difference of temperature
of the junction to other parts of those conductors.
resistance temperature detectors (RTDs), are sensors used to
measure temperature by correlating the resistance of the RTD
element with temperature. Most RTD elements consist of a
length of fine coiled wire wrapped around a ceramic or glass
core. The element is usually quite fragile, so it is often
placed inside a sheathed probe to protect it.The material
has a predictable change in resistance as the temperature
changes; it is this predictable change that is used to
determine temperature.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
describe flow nozzel principle?
what is the reason while warning lamp is on while the engine is cranking?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How d.p. Transmitter can be applied to close tank?
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
Why do we have earthing cable in branch cable and shield in the same cable?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
How is automatic reference junction compensation carried out in temperature recorders?
What is instrumentation control?
Specify ideal accuracy of flow element like orifice plate, Ventury, Annubar. Ultrasonic flow meter etc.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
Calibration of controller (pneumatic)
how to design orifice plate?what is the equation?
how can we tune a PID. If it is by zeiger nichols method..please explain briefly with help of an example.
