Can anybody tell me why inductors draw lagging current and
capacitors draw leading current from supply?
- 4 Answers
- 8099 Views
- I also Faced
- E-Mail Answers
Answer Posted / gokul sapkota
capacitor is the current generating component where as inductor is the current consuming component
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
what is the function of gss in the dg set.
On what basis the the size of Lightning arrester for buildings are selected ?
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
What are high pass filter and low pass filter? and What are the flowmeter ?
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
What are reasond for high wattage in single phase induction motors
What is industrial plc
What are the raitings of Mcb,mccb and Acb in detail ??
mccb service sittings be done?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
Why does the adjacent zone of protection overlap?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
write a program that prints prime numbers from 1-20 in digonal form
what is the use of expulsition protective gap in 11Kv line.
