Interested to Buy Any Domain ? << Click Here >> for more details...
Can be operate control valve without positioning if yes ?
how and why?
- 4 Answers
- 7384 Views
- Focus, I also Faced
- E-Mail Answers
Answer Posted / sanjoy panda
Without position-er all the control valve operate but it operating criteria is not satisfy our requirement. Error will be produced very large, and response will be very slow . To avoid on those error we have to use position-er.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Vibration Probe (Axial, Redial) in field
what is interface level and how it is calibrate?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
How is PH sensor works ?
how u choose thermowell lenght n pnumatic C/v size?
What do you know about gail?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
what is the criteria to decide conductor size of a cable ?
What are different types of control valves?
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
How to calculate P,I&D value in PID controller ?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
