Why in Digital Megger for finding Insulation resistance,-ve
is applied to core or conductor and +ve is applied to
ground.
- 1 Answers
- 3182 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / ramesharavind s
in we throw the + wire in gnd when we find the how much
current flow in gnd wire and'll then as per ohm's law we
find the resistence of gnd.
so we always connect the +ve in gnd.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Is a d.c.compound motor is use as a booster? how?
What is dynamo?How it works and what is the function of dynamo in a DG.
how we can calcultae the short circuit level for bus bar
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
What is a compensator?
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
How calculated single phase induction motor req. Capacitor?
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
