Interested to Buy Any Domain ? << Click Here >> for more details...
The DCS stand for________________________. it is composed of
the following major components:
a:______________
b:______________
c:______________
d:______________
- 2 Answers
- 5435 Views
- I also Faced
- E-Mail Answers
Answer Posted / pramod singh
distributed controll system is a remote controll system to
controll different logical ckt from single location as many
way of controll. it is a center of group logic controll .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
What is the difference between mmwc and mmwg?
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
Definition of reverse and acting controllers:
What is hp & mp seperator .& what is its working principle ?
How to calibrate smoke Dectector
Using your own examples solve a problem involving normal table. (experimental method and analysis)
how do calibrate the valves.. with clear manual
How many ohms are required for proper earthing?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
I want to measure and control level in tank of size 10*5 filled with gasoline, so plz give me the solution with clear details. how to select transmitter and sensors.
If fire would be inside the plant which fire detector is to detected the fire.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
