What is difference between AC and DC resistance
- 9 Answers
- 28411 Views
- Eaton, I also Faced
- E-Mail Answers
Answer Posted / harikrushna adalja
DC
You can easily work with resistance in DC circuits
because DC is a steady, constant flow of current. The
relationships between resistance, voltage, current and power
come directly from Ohm's Law.
AC
In contrast to DC's constant flow, AC alternates between
negative and positive peak values 60 times a second. The 110
volt AC is 110 volts only at its momentary maximum. Though
Ohm's Law applies to AC at any given instant, you determine
power and heat by finding an average current value.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the diff. between x'mer , isolation x'mer & ultra-isolation x'mer ?????????????
full form of flry b
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
what is difference between 5A and 100A CT constructional wise and operation?
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
Type of motor stater detail and working detail
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
what is the difference between electrical and electronic choke?
Why CBCT rating is 50/1A
Disadventage of cable-gland earthing if any ?
What is inrush current? how can calculateit? what is the affect of it?
2 v/500amp/hr to 1.80vpc at 20 degree celsious 2v/5ooamp/hr to 1.75 vpc at 77degree farren .this is the capacity of a battery .what is the meaning of this . can i get a detailed explenation
hi plz send me reliance placement papers..i.e electrical technical papers that have been asked in reliance test.
What is the purpose of stablization resistor in high impedance bus bar protection
