Answer Posted / hansraj ,ainch
The power which are
using for work is called
LT and HT is use for
only transmition.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
What is the difference between resistance grounding system and resistance earthing system?
How grounding is different than earthings?
Why do we use center tap transformer that used with portable tools
What is the use of bundle conductors?
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
What should be the height of basement according to NBCC code?
what are the factors to be considered while design the breaker either HT or LT??
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
how point on wave controller works.
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
Can i use the B-curve MCB instead of C-curve MCB
The windings of a transformer are divided into several coils, because?
how dose servo motor works
can any one suggest paper presentation topies for electrical engg?
How could a garment factory benefit from renewable energy
