In a 11Kv/433Volt Delt-star step down transformer one one
line(Line-B) of HT site is open & earthed on DP structur.
What will be the voltage on LT side R-Y, Y-B,B-R and R-N, Y-
N & B-N?. Please help to understand the problem with
examples.
Arvind , Jaipur.
- 1 Answers
- 3499 Views
- I also Faced
- E-Mail Answers
Answer Posted / srk
240,240,433............240,0,240
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
What is difference between slip rings and carbon burushes?
Explain cmrr?
What is essential to prove safe isolation of electrical circuit?
Earth bits close or open. Which is correct
On Which Pressure PRV is operated.
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
Merits & Demarits of Oil circuit & Air circuit breakers ?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
what is the difference b/w ATS and HTS?
what is Fault level? why it is calculated? how will u decide same for our plant?
