Interested to Buy Any Domain ? << Click Here >> for more details...
why u want to work in sail/ntpc as u r already in an it
company where life is good, good environment no much
tensions etc?
- 6 Answers
- 15000 Views
- Sail, I also Faced
- E-Mail Answers
Answer Posted / sanjay
ALSO 6)other allowances and accomodation increases net
package in sail/ntpc.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
What are the advantages and disadvantages of open loop control system?
what are the things that can cause a three phase motor to crawl?
Write masons gain formula.
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
How are load losses and no-load losses measured at site in a DG set?
what is saturation kit?which use above 15 kw motors panel side.
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
How to calculate the sag on transmission Lines.
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
