Interested to Buy Any Domain ? << Click Here >> for more details...
low voltage distribution is done by
a)3 phase 3 wire
b)3 phase 4 wire
c)single phase
- 3 Answers
- 5444 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
c) single phase
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
what is the internal working of star delta starter
How 48-relay (incomplete sequence) functions?
l&t switch FN 63 handle position can we change
What is servo motor? what is its purpose?
54 Comments Alok and Bhanu play the following min-max game. Given the expression N = 38 + X*(Y – Z) where X, Y and Z are variables representing single digits (0 to 9), Alok would like to maximize N while Bhanu would like to minimize it. Towards this end, Alok chooses a single digit number and Bhanu substitutes this for a variable of her choice (X, Y or Z). Alok then chooses the next value and Bhanu, the variable to substitute the value. Finally Alok proposes the value for the remaining variable. Assuming both play to their optimal strategies, the value of N at the end of the game would be?
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
is it possible to have dc motors on single chip
what is the meaning of neutral displacement ???
Dears we deal in Chemical are Plate earthing. Kindly call if any requirement and questions. Tech Earth Solutions Mohit Verma 8791071007
Starting times for soft starter & power factor is thier any standard or datas available in manufactures list. Kindly suggest.
in what type of applications v can use q meter?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to calculate the formula of cable size if motor kw is given
sir vizag steel ka junior trainee ka paper kitne number ka ayega
block diagram of 2 ups system connected in parallel mode?
