Interested to Buy Any Domain ? << Click Here >> for more details...
which element is neglected during fault calculation?
a)resistance
b)inductance
c)capacitance
d)reactance
- 4 Answers
- 8367 Views
- I also Faced
- E-Mail Answers
Answer Posted / akash
RESSISTANCE is the right answer as short circuit current
mainly depends on reactance i.e Inductance and
Capacitance .ressistance basically resposible for decay in
dc current and in short circuit case ac is very large.thus
ressistance can be neglected.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
why using transformer and thyristor switch in 3 phase apfc panel
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
please send privious years question papers of jindal steel and power ltd.My e mail id is rajanikant.sngh@gmail.com
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
What if the difference beween internal and exrteranal LBB?
Can a generator runs after getting 1st stator earth fault.
what is meant by directional earth fault and non directional earth fault? describe both.
how to calculate the loss tangent of electrical cables
what is the difference between RMS & TRUE RMS VOLTAGE
How calculated single phase induction motor req. Capacitor?
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
Phase control and integral control are used for?
why burdens of VTs is more than CTs?
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
