what is diffrence between primary & secondry transformer?
Answer Posted / h.p.sahu
The primary side connected to Power supply side Where as
the load is connected to seconadry side.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what type of motor used to move a 1 ton gate? and relate ratings with load.
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
why use phase displacement in transformer.and effect of phase displacement on transformer
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
What does ampere turns shows?
Define filter?
For a three phase induction motor, what will be the effect on motor if the neutral of the system is shifted to say 20 deg.?
design a 3 bit synchronous and asynchronous counter using T- flipflop
How to test Alternator stability test for REF relay
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what is the difference between circular wdg & ractangular wdg?
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
what is counter poise conductors