Answer Posted / chee
glass,rubber,wood,plastic.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the use of chuck?
What are the causes of steam turbine failure?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
What are the procedures on how to anneal?
why the path of a satellite is always elliptical with earth not at the centre of the ellipse?
What are the causes of turbine vibration
How is the aptitute test done
why constant pressure is consider for thermal diffusivity??
What is meant by direct heat exchanger [or] open heat exchanger?
How do you control cylinder liner wear?
Can anyone explain Things gone right(TGR) and Things gone wrong(TGW) in the APQP process? preferable With example.
Explain how the cylinder lubrication on main engine is done?
what is tranformer and transducer
what is critical temprature discuss that is any pressure greater than critical pressure is valid for boiler design.....2 in what cycle steam power plant is based draw h-s diagram.different process to make gear what is tooth profile what is generatic and directric and many more as i m doing mtech thats why interview was of 30 minute...........