what is AVR and tell principle and working?
- 10 Answers
- 38337 Views
- ITC Infotech, MIOT Hospitals, YCC, I also Faced
- E-Mail Answers
Answer Posted / santoshvarma
AVR is used for regulating the voltage for synchronous motor
or generator. To change the field excitation of the rotor.By
this the motor or generator can be maintained at unity power
factor by over exciting & under exciting whenever needed.
| Is This Answer Correct ? | 10 Yes | 6 No |
Post New Answer View All Answers
what is the difference between circular wdg & ractangular wdg?
how to calculte capacitor range for single phase induction motors??pls tel
explain remenance . differentiate high remenance type ct & low remenance type ct
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
how does it help for selection of a transformer.
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
What is safety of Ht panel
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
What is a feedback in control system?
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
What does the term “voltage regulation” means?
How to calculate MCB Breaking capacity.
Grid fault level [KA]?
