Interested to Buy Any Domain ? << Click Here >> for more details...
how we can know which is Lv side and HV side of transformer
by just seeing it?
- 7 Answers
- 25163 Views
- I also Faced
- E-Mail Answers
Answer Posted / balasimha rao
for any distribution transformers there are three bushings
on HV side and four bushings on LV side
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
from generating station If 400v LT line length is 1000m how much voltage is drop and how do i calculate it? which cable will be use for this line?
What type interview questions ask in Electrical technicians
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
how to calculation increase capacitor,increase power factor for three phase.
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
What are the uses of lead compensator?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
why single CT used in DOL starter power circuit?
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
