Interested to Buy Any Domain ? << Click Here >> for more details...
In the solution of load flow eqation, Newton raphson method
is superior to the gauss siedal method because
(a)the time taken to perform one iteration in the NR method
is less when compared to GS method
(b)the number of iterations required in the NR method is
more compared to that in the GS method
(c)the number of iterations required is dependant on the
size of the system in the NR method
(d)convergence characteristics of the NR mehod are not
affected by the selection of the slack bus
- 1 Answers
- 4504 Views
- I also Faced
- E-Mail Answers
Post New Answer View All Answers
how to identify conection leads of an unknown electric motor
Ceiling Fan and Storage type water heater. Discuss
What mean by MLTP
What is effect on in zone and out zone fault if CT chosen for phase side is Vk/2<5mA and Neutral side is Vk/2<15mA on REF protection of Transformer
What is mean by hot and cold loop testing? What is the difference between them?
What is hipot test procedure?
What is the function of NGR for the parallel operation of alternator? whats happen when different rating of alternator are running with parallel?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
how to discharge 3 phase power factor correction capacitors
What are the different types of controllers?
Whats the difference btwn a latch, port,data bus buffer? Do they all not hold data in d flip flops??
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
what is the difference between vector scale and vector diagram?
operation of protection relay watchdog contact?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
