Interested to Buy Any Domain ? << Click Here >> for more details...
why two contacts(in series) are using in closing circuit
- 3 Answers
- 5958 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You mean 2 contacts are made in series in a MCB? That is to
make doubly sure of opening the circuit.If parallel ,it is
to make closing doubly sure ,as you can expect one of the
contacts to open or close definitely .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
There is any especial requirement for motor to drive through with VFD?
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
concept of busbar and load dispatching..?
State kirchoff voltage law?
What is speed mode?
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
what is the transmission loss for electrical supply? specifically a large shopping complex where the grid is half KM away, what will the % of transmission loss? is there any transmission loss for captive unit generation for above set? thanks
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
What are the various kind of cables used for transmission?
What is the method of estamating of cable, CB,MCB ?
Explain how to determine capacitor tolerance codes?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
what is breathing?
Why derivative controller is not used in control systems?
