Interested to Buy Any Domain ? << Click Here >> for more details...
Ns=120f/p. what is 120?
- 10 Answers
- 107204 Views
- IAR, L&T, Ramada, Toshiba, I also Faced
- E-Mail Answers
Answer Posted / shriram.n
speed=2*60f/p
where
2=?
60=min.
f=frequency
p=pole
we can find speed of motor through below fprmula also
i.e
speed=60f/p
where
60=min.
f=frequency
p=pairs of poles.
example
s=120*50/4=1500rpm
like s=60*50/2(4pole have 2 pairs)=1500rpm
| Is This Answer Correct ? | 17 Yes | 15 No |
Post New Answer View All Answers
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
Which type of transformer is used for lighting loads?
why high speed tripping relay is used in protection circuit why not normal relay
How to calculate mf when meter equipment and meter are connected
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
If we connect a motor and generator together (I mean that the generator gives the motor electricity and the motor gives the generator movement) regardless the losses. Will the generator still generate and the motor still move?
Why do power lines not short out when they fall into water?
What are protections for dty type transformers
what is through fault?
how many electricity poles are there and what are the names and their sizes.
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
Why is the air gap between the pole pieces and the armature kept very small?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
My load is 1635 KW. & current pf is 0.884, I have to improve it for 0.99.Please suggest what KVAR value is needed?
