Interested to Buy Any Domain ? << Click Here >> for more details...
what is the physical phenomenon because of which skin
effect occurs ??
- 6 Answers
- 11184 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / arindam paul
skin effect occurs due to nonuniform flux linkage in the
conductor portion. thus inductance of conductor portion is
not uniform i.e. at the conductor surface inductance is low
and at centre of the conductor is maxm. so current density
at centre is minimum and at surface it is maximum. Due to
increment of frequency this effect is more pronounced.
For dc current there are no skin effect.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
single phase power supply give to separate one steel coup with water, what reaction create
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
The power factor of the fixed load is 0.8, now the p.f is varying from 0.8 to 0.5.
what will happen if OLR CT in all phases are short circuted
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
What is meant by derating factor?
how to compute kAIC? with formulas...
what is transient voltage?
can mini-curcuit supply MIL-tested transformer !
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
