Interested to Buy Any Domain ? << Click Here >> for more details...
What do you mean by boost voltage in case of battery
charger?
- 3 Answers
- 30256 Views
- MahaGenco, I also Faced
- E-Mail Answers
Answer Posted / ganesh bhangale
Battery charger having two mode of charging
1)Float charging ( constant voltage charging )
2)Boost charging ( constant current charging )
When battery goes for small discharg up to 10% it could
charged by float charging but if the battery goes to deep
discharge up to 50%it needs boost charging. In boost
charging keep the cell voltage of lead acid battery 2.65 &
charging current set 10% of AH capaicity of battery bank
Due to upper voltage level of batery charger battery takes
current & this current is controlled by charger controller
or by varing potentiometer( ie current limit pot)
| Is This Answer Correct ? | 17 Yes | 1 No |
Post New Answer View All Answers
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
what is the Pickup/drop off ratio in BCPU relays
What do you mean by distribution transformers?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..
What is the end effect of linear induction motor ??
mccb service sittings be done?
what purpose to use excaiter in DG.?
how to determine Sq.mm size of finolex power cables.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
what is meant by impedance & transient protection?
