what is the difference between surge arrestor and lightning
arrestor ?
- 6 Answers
- 18949 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramakishore karri
lightening arrestor are located outside for outside atmospheric lightning.
surge arrestor are located inside generally outgoing of the circuit breaker but the purpose is same in both cases.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
explain different types of d.c motors?
What are the parts in a inverter?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
why any centrifugal blower draw more current in starting. consider id fan and fd fan?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
what is the solution for meger test failed the MV cable?
Define what is the function of anti-pumping in circuit breaker?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
salam,hi, i need to know what the spesification of 300amp msb...
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
how to select correct size of power cable for inverter duty motor
