Interested to Buy Any Domain ? << Click Here >> for more details...
What is a doble test
- 1 Answers
- 4999 Views
- KPSC Karnataka Public Service Corporation, I also Faced
- E-Mail Answers
Answer Posted / rk
The insulating power factor test, better known as the ”Doble
Test”, is a complete overall test of the insulating
properties of a transformer. Elements such as carbonization,
ionization, moisture, and heat can breakdown the
insulation's strength. The Doble test measures the power
losses due to leakage current through the insulation.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
how to calculate current and voltage in a same circuit?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
What are the essential characteristics of signal flow graphs?
How to decide cable tray size?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
why we use ac supply as 415 volts instead of 415 v why we cant apply 230 v for dc
what do you mean by class PS CT and what are technical details needed for calculating it?
2- What are the percentages between excitation currents in phase (R, S and T) in ∆ and Ỵ connections in excitation Current test in transformers?
where is core-type and shell-type construction suitable for transformers ?
What is polar plot?
what is the purpose that we use PLC system in power system
At what factor resistance r of a conductor depends?
