Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vlad
Vibration Probe is an vibration sensor...
When sensor recive hi vibration, send the signal to the
system and the motor will be shut down....
| Is This Answer Correct ? | 3 Yes | 13 No |
Post New Answer View All Answers
How to calibration a control valve?
what is the difference between -24 : +24 & 0:24 and where it use?
Which topics are covered in Process Control?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
it is possible to check the fail safe condition in pressure transmitter. if possible how?
What is super thermocoupal?
How will you calibrate PID controller? explain with example.
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
Why do we have earthing cable in branch cable and shield in the same cable?
what is the difference between magnetic flow meter and mass flowmeter
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
What is the GK Value in Flowmeter?
Why MUX JB's are using only Temperature Element in Fundation field bus?
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
