why we cant
control neutral
instead of phase in
single phase?
- 3 Answers
- 3724 Views
- I also Faced
- E-Mail Answers
Answer Posted / shoebullah
see brother, we no need to
control neutral because its a
return path for the phase ......
Always remember flow of
electrons will work ...
Controling of neutral is no
use...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
Write down the design procedure of commutaj.
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
can we choose current transformer secondary, to calculate residual flux in a power transformer, so as its saturation is close to the saturation level of power transformer?
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
What is essential to prove safe isolation of electrical circuit?
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What does bode plots shows?
how we calculate the dick for a pole?
How can calculate the rating of a alternator for a given specific load with formula
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What happen to generator if i have unbalanced load?
