Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / prasanna kumar das
To prevent the equipments from lightning strokes. Because
the cloud is negatively charged at bottom it requires a zero
or a positive potential to discharge, and it selects the
ground (Zero potential) to discharge. If the Telecom
Equipments are fed with positive the cloud will choose the
low resistance tallest positively charged Antenna's to
discharge, this could damage the entire setup of Telecom
equipments. So the Telecom equipments are fed with Negative
supply Voltage
Read more:
http://wiki.answers.com/Q/Why_telecom_equipments_work_in_negative_voltage#ixzz23mgK9os7
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Write the current equation in series RLC circuits.
why we get 2 differnet values for power factor in 2 watt meter method in 3 phase
how oti and wti connections are different from each other?
How do we calculate over and under frequency tolerance from generator data?
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB Machines of higher rating?
design of IGBT firing circuit for 11KV
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)
hai friends i have BSNL JTO exam on next month so if any body have model question paper or give preparation tips to my mail id kumar4486@yahoo.co.in this will helpfull for my future .plz & thank u by kumar
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
What is an alternator impedance value?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
What is the difference between security constraint unit commitment and security constraint optimal power flow?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
