Interested to Buy Any Domain ? << Click Here >> for more details...
What will be happend if we not ground CT secondary?
- 3 Answers
- 8333 Views
- Enercon, Engro, THDC, I also Faced
- E-Mail Answers
Answer Posted / dwara.55@gmail.com
If the secondary of the CT is not grounded or short circuited
then the secondary current will become zero hence the ampere
turns produced by secondary will oppose the ampere turns of
primary(i.e brings to zero). So, there is no counter m.m.f so
high flux is produced in the core thus overheating of core is
produced. Similarly high e.m.f will be produced both in
primary and secondary this will damage the insulation of
winding. Thus for safe operation for the operator the
secondary must be grounded properly
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
What are the advantages of a three-phase system over a single-phase system?
What is sensitivity of a measurement?
why is using sensor?what is differece between photoelectric and proxmitty?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
Brief me about maintenance planning & sheduling of machine tool.
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
how to calculation increase capacitor,increase power factor for three phase.
what is plunger and what's the use of it in motor alignment?
two way ckt diagram can be drawn by how many ways? give diagram
A 1F capacitor is charged to 100V initially. A 1H inductor is connected accros the capacitor througha a switch. The current in the circiut when the switch is closed is____
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
substation+ plc system
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
