Interested to Buy Any Domain ? << Click Here >> for more details...
why 400Hz is used for aircraft systems ?
- 14 Answers
- 55461 Views
- Cabin Crew, Jet Airways, I also Faced
- E-Mail Answers
Answer Posted / mahesh
It is mainly to reduce the size of the electrical equipment.
As, flux is inversely proportional to speed(frequency). so
as freqwuency increases, flux reduces. thus the core size
gets reduced.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
CAN WE CALCULATE THE NEGATIVE SEQUENCE AND ZERO SEQUENCE REACTANCE OF A GENERATOR USING ONLY ITS RATED VOLTAGE, KW, PF AND SYNCHRONOUS REACTANCE??? IF YES, THEN HOW??
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
What is bridge rectifier and explain with details
how to identify the cable quality and what is flame proof cable
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
which type of cabel
how to test power transformer.YNd11
How 3 phase invertor works?
how to calculate the formula of cable size if motor kw is given
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
why high speed tripping relay will be used in tripping circuit why not normal relay
how to check regenerative load in drived motor
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
