Interested to Buy Any Domain ? << Click Here >> for more details...
Our Alternator nameplate specifies a power factor of 0.8.
When the Alternator is on light load, the bus bar voltage
rises to 11240 volts, whereas the standard value is 10500 volts.
Is it ok to increase the power factor to 0.85 or 0.9. I am
afraid because the power factor on the name plate is only 0.8 ?
- 3 Answers
- 6610 Views
- Escube, I also Faced
- E-Mail Answers
Answer Posted / monty
.8 power factor means it is designed to run on that minimum
power factor but you can run it up to .99
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
application s to shunt coil
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
What is meant by reactance voltage?
what is the efficiency of thyristor
You are of electrical field and you are going for software? Why
thyristor controlled APFC panel design parameter?
What safety precaution are to be taken for avoiding electric hazards ?
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
how to calculate earth fault relay current and CBCT ratio
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
write down the formula of cable size in RM if current is 50Amp.
What is the formula to calculate the rating of power cable for three phase current.
How to size Air Circuit breaker (ACB)? What is the most important factors?
explain the functions of main isolation switches
