Interested to Buy Any Domain ? << Click Here >> for more details...
Where we r using split range and ratio controller?
- 1 Answers
- 6611 Views
- EID Parry, I also Faced
- E-Mail Answers
Answer Posted / sivaram
To maintain the PV out put related with two different process
then out put should be split Ex:-Steam turbine Hot well level
control 1) PV: Hot well level 2)split out put1:inc to dec
action 3)Split out put2:Inc to Inc action ,and valves also
designed reverse action.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
you are on site,the plant trips,you are approached by operations,what do you do?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Q- What are the application in which PNP transistor is preferred over NPN ?
what is the minimum power (P=VI)to produce a spark?
components of control circuit belongs to control valve
What is the constant voltage unit?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
which type of filter gives the constant phase characteristics?
what is the different between deflection type measurement and null type measurement in RTD?
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
How would you choose differential range?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
How will you calibrate PID controller? explain with example.
Describe the function of Accumulator into the Pump
