Interested to Buy Any Domain ? << Click Here >> for more details...
What is the direction of rotation of blades in a table fan
and in a ceiling fan ?
- 11 Answers
- 19701 Views
- Power Grid, I also Faced
- E-Mail Answers
Answer Posted / tpfasil200
ceiling fans rotate both ways 'anticlockwise' and 'clockwise' this is so the on fan will pull the air up and another will push it down to create a circulation in the room. Table fans rotate clockwise so they can push the air outward across the room.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
plz send me the placement interview question and answers of whizchip(technical and apttitude)..i have an interview in next.
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is an automatic controller?
What is the BS(British Standard)code for 11kv motor
Why can't we parallel the secondary circuits of two voltage transformers?
is it possible to start a motor in felid connected to a remote mcc
explain types of electric welding and its applications
what is the chemical name and formula of refrigarent R-134a.
WHAT IS THE DIFFERENCE BETWEEN GENERAL INVERTER AND SOLOR INVERTER TELL ME PLZ
SIR, GIVE ME OPGW SAG CALCULATION FORMULA I AM DAE ELECTRICAL. THANKS
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
LT cable fault chaecking equipment and to find out the distance at what distence it failure . Name and where it is available?
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What is the basis for framing the rules of block diagram reduction technique?
