why earth hole size is biggest in plug point?
- 22 Answers
- 39028 Views
- Al Qabas, HCL, RRB, I also Faced
- E-Mail Answers
Answer Posted / ashli
earthing is provided for protection, ie if the body of an
equipment is in contact with current carrying conductor,
the current has to be bypassed to earth so as to avoid
human from getting electric shock. this is done by earthing
the body of the equipment. by earthing we are providing a
low resistance path.ie any how we need to reduce path
resistance. resistance is inversily proportional to area of
cross section of path. thtz y earth hole size is made
bigger. hope u got the point
| Is This Answer Correct ? | 30 Yes | 5 No |
Post New Answer View All Answers
can anyone give an idea about dia calculation in cold rolling mill
why zero sequence impedance measurement is not applicable for single phase GT
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
how to calculate the Neutral transformer impedance?
distribution is maximum done by a)radial b)network c) parallel d)b & c
explain PV modules in solar energy generation.
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
wheather the size of windings in motor and generator are the same
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
What is meant by reset level of the relay?
why we are using earth pit in sub stations.?
block diagram of 2 ups system connected in hot stand by mode?
What is bode plot?
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
How to calculate the size of earth cable to earth the neutral of UPS ?
