I have been short listed for sydicate clerkcal post .i have
interview on 15th sept..i want to ask if i don't know
kannada to read and write they won't allow me to attend the
interview?Do send u r reply.......
Answer Posted / k.prakashchandra
Don't worry you will be allowed to appear for interview as
they have branches all over India
Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
what is PID control in VFD drives?
What will happen to the protection and metering, if the polarity of a single or two PT/PTs in three phase system is reversed? Please provide reference if any.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
why does make gain margin and phase margin on same plot.?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
Can i use the B-curve MCB instead of C-curve MCB
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
I HAVE BEEN SELECTED FOR APGENCO A.E(ELECTRICAL) 2008.HOW MUCH WEIGHTAGE FOR INTERVIEW AND WRITTEN TEST.HOW I HAVE TO PREPARE. PLEASE GIVE INFORMATION IF U KNOW.WHAT ABT G.D THIS TIME.CALL RATIO 1:2
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is differnce btwen lll and lllg faults
How work of capacitor in dc supply...???
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
how to test and calculat the head and discharge in borewell compressor
What is MS-EXCELL?
What is Negative Potential Bias