Interested to Buy Any Domain ? << Click Here >> for more details...
Which mechanical device is used in pressure gauges to reduce
pulsating
- 4 Answers
- 7163 Views
- I also Faced
- E-Mail Answers
Answer Posted / sajid ali khan
First let me correct the Question itself a little. It
should read " Which mechanical devices are used to minimise
or dampen pulsations in pressure gauges".
Answer:
Process Pulsations expecially those at the dicharge od
reciprocating pumps can be very problematic for
measurement. The pulsations can also make pressure reading
difficult.Frequently, they can even damage pressure gauges
beyond repair and it is important to curtail these such
pulsations.
Normally three devices are used.1) Pigtails, which are
simply a mild steel pipe or Stanless steel tube bent in a
full circle, it is installed between the pressure tapping
and the gauge, with inside diameter a little less than the
tap dia. The Process Pressure dampens while traversing
though the pitail.
2) A restriction damper, that has sometimes a variable
restriction of a conical piece inside a matching chamber.
The process pressure has to squeeze throughh the annualar
space and demapens.
3) A hollow cylindrical chamber, that acts as capacity to
reduce the pulsations.
Sajid Ali Khan
engineersajid52@gmail.com
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how to calibrate corollaries (Mass flow meter)?
what is a half wave, full wave, and bridge rectifer.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
what are the selections available in configuring a burnout protection of a controller? thanks
what effects a surging can produce in the compressor
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
can we create an interrupt in plc through scada?
how to design orifice plate?what is the equation?
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
What are de-saturators?
What is mean by analytical instrumentation?
this site is owned by an nonsense
Differentiate between ultrasonic flowmeter and radar type flow meter
