Interested to Buy Any Domain ? << Click Here >> for more details...
What is the meaning of Feedback? How many types it is?
Explain it?
- 2 Answers
- 5927 Views
- Bharathi Cement, I also Faced
- E-Mail Answers
Answer Posted / machireddypavan
Feedback is a process of some part of output signal is feed
in the input
signal.
2 types. 1) positive feedback
2) negitive feedback
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
Where is wet leg is used?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
how many types of preheaters are in cement industry & what r they can any body explain?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Isometric drawings are generated during _________________ phase of a project
draw shematic diagram of c/v positioner(smart type)?
What is the start up procedure of desalter
Explain about the leakage class of the control valves
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
What are different type of instrument cable
How does your previous experience relate to the job you are applying for ?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
how to measure draft pressure in transmitter pl. give its single line digram
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
